====== NMAP ======
===== Découverte des stations (hosts) =====
commande ''sudo nmap -sP %Network%''
<code bash>
> sudo nmap -sP 192.168.1.0/24

Starting Nmap 7.60 ( https://nmap.org ) at 2021-06-02 10:02 UTC
Nmap scan report for _gateway (192.168.1.1)
Host is up (0.00017s latency).
MAC Address: 78:8A:20:44:CF:65 (Ubiquiti Networks)
Nmap scan report for 192.168.1.2
Host is up (0.0025s latency).
MAC Address: 78:8A:20:40:A3:7A (Ubiquiti Networks)
...
Nmap scan report for Linux (192.168.1.88)
Host is up.
Nmap done: 256 IP addresses (29 hosts up) scanned in 4.43 seconds
paradmin@paradmin:~$
</code>
===== Scanner les ports d'un Host =====
<note>On peut combiner les deux UDP et TCP avec :\\
''sudo nmap -sU -sS %IP_HOST%''
</note>
==== TCP ====

Commande ''sudo nmap -sS %IP_HOST%''
<code bash>
> sudo nmap -sS 192.168.1.200

Starting Nmap 7.60 ( https://nmap.org ) at 2021-06-02 10:06 UTC
Nmap scan report for 192.168.1.200
Host is up (0.0038s latency).
Not shown: 996 filtered ports
PORT     STATE  SERVICE
2222/tcp open   EtherNetIP-1
9003/tcp open   unknown
9009/tcp closed pichat
9010/tcp open   sdr
MAC Address: 20:AA:4B:22:67:CF (Cisco-Linksys)

Nmap done: 1 IP address (1 host up) scanned in 16.49 seconds
</code>
==== UDP ====
Caommande ''sudo nmap -sU %IP_HOST%''
<code bash>
> sudo nmap -sU 192.168.1.200

Starting Nmap 7.60 ( https://nmap.org ) at 2021-06-02 10:11 UTC
Nmap scan report for 192.168.1.200
Host is up (0.0038s latency).
All 1000 scanned ports on 192.168.1.200 are open|filtered
MAC Address: 20:AA:4B:22:67:CF (Cisco-Linksys)

Nmap done: 1 IP address (1 host up) scanned in 21.44 seconds
</code>



====== Sources & Ressources ======
  * [[https://nmap.org/man/fr/]]
  * [[https://www.networklab.fr/scan-reseau-nmap/]]